Changes

Another thing to consider is that achieving a pH of 4 as fast as possible is advisable for preventing off-flavors from contaminating microbes <ref>[https://www.facebook.com/groups/MilkTheFunk/permalink/1180630378631841/?comment_id=1181674265194119&reply_comment_id=1181715048523374&comment_tracking=%7B%22tn%22%3A%22R7%22%7D Conversation with Bryan of Sui Generis Blog on MTF regarding speed of acid production with Lacto. 11/20/2015.]</ref>. Larger pitch rates tend to achieve a lower pH faster <ref name="bryan_lacto_starters"></ref>. Therefore, unless using [[Lactobacillus#Samuel_Aeschlimann.27s_Starter_Procedures|Samuel Aeschlimann's starter procedure]], pitching 0.5-1 liters of starter for 5 gallons of wort is advisable in general. Even when using [[Lactobacillus#Samuel_Aeschlimann.27s_Starter_Procedures|Samuel Aeschlimann's starter procedure]], over-pitching ''Lactobacillus'' is not a concern, so the same pitch rate of 0.5-1 liters for 5 gallons should still be considered unless the brewer is confident that high growth rate has been achieved in the starter, in which case 100-125 mL for 5 gallons of wort/beer should be adequate (again, exact pitching rates for ''Lactobacillus'' are generally not as important as they are for yeast pitching rates). Other factors that might affect the effectiveness of a volume based starter is the species/strain of the ''Lactobacillus'' being used, how much yeast contamination has occurred, and how old the ''Lactobacillus'' starter is. Some species/strains may require a larger volume of starter, as well as if yeast has contaminated the starter or wort (see [[Lactobacillus#100.25_Lactobacillus_Fermentation|100% Lactobacillus Fermentation]]). If a ''Lactobacillus'' culture is older than 1 month, then a fresh starter should be made. Keeping a separate Erlenmeyer flask for ''Lactobacillus'' starters can help to prevent yeast contamination <ref>Private correspondence with Richard Preiss to Dan Pixley. 11/20/2015.]</ref>, as well as using sterilization equipment such as an autoclave or pressure cooker.

Although more experiments and probably needed, agitation is believed to be an important factor for both yeast and bacteria in general. Gentle stirring on a stir plate or orbital shaker, or frequent gentle manual agitation leads to faster growth and a higher number of organisms. Agitation keeps the microbes in solution. It also maximizes the microbes' access to nutrients and disperses waste evenly. In a non-agitated starter, the microbes are limited to the diffusion rate of nutrients, leading to a slower and more stressful growth <ref name="bryan_agitation">[https://www.facebook.com/groups/MilkTheFunk/permalink/1168024059892473/?comment_id=1174865305875015&reply_comment_id=1176092372418975&total_comments=1&comment_tracking=%7B%22tn%22%3A%22R9%22%7D Conversation with Bryan of Sui Generis Blog about starters and agitation. 11/09/2015.]</ref>. If agitation is not possible for whatever reason, a successful starter can be made without agitation. Sam Aeschlimann reported good success with ''Lactobacillus'' starters that are not agitated <ref name="Sam_starter2"></ref>.