Gose

From Milk The Funk Wiki
Revision as of 14:39, 27 July 2017 by DanABA (talk | contribs) (added Historical link "Gose from Goslar was probably fermented with yeast residing in spruce barrels (Benedikt Rausch's blog).')
Jump to: navigation, search
Ritterguts Gose is still made to the traditional German recipe.

Gose (Goes-uh) is a salty, sour, beer from Goslar, Germany that is brewed with at least 50% malted wheat (although a few historical sources say that Gose was brewed with 100% wheat [1]). Gose has a low hop bitterness and aroma and gets a lemony character from the use of coriander. The straw-like colored Gose (2-6 SRM) sits at a sessionable ABV around 3-5%, made up of mostly pilsner and wheat. Gose is usually unfiltered, so some haziness is to be expected [2].

Historical

Historical texts suggest that some versions of Gose underwent an initial spontaneous fermentation that formed a "leather like" barrier over the beer, and yeast was only pitched when the beer "was given away". A bacteria described as "Bacterium acetosum" in 1897 was identified as one of the important microbes that make Gose. This bacteria was described as an acetic acid producer, and could also be used to make vinegar. This bacteria was also hypothesized as being responsible for forming this "leather like" pellicle, although speculation includes the possibility of the presence of a SCOBY. Some sources indicate that Gose was also bottled in thin long neck bottles without a cork, and the bacteria reformed the "leather like" pellicle in the neck of the bottle that when dried out captured the CO2 in the bottle (the exact mechanism of how the "pellicle" dried out and became sturdy enough to hold carbonation is not understood). Coriander was not traditionally used in the brewing of Gose, but spruce branches were used for lautering and spiced versions used Vermouth and Cinnamon. Gose had less lactic acid than Berliner Weisse, however it was described as being more sour than Berliner Weisse. This was probably due to higher amounts of acetic acid in Gose from the spontaneous fermentation and the acetic acid producing bacteria [3][4].

Most historical Gose beers were probably brewed with 100% air dried malted wheat, although one example was reportedly brewed with 55% barley malt. Table salt was often added, and/or highly mineral water [1]. The original gravities of historical Gose seemed to change through time. In the mid 1850's, they seemed to be around 13-14°P (1.053-1.057 SG). In the early 1900's, the original gravities seemed to become smaller at around 9-10°P (1.036-1.040 SG), although some versions were still brewed with the higher starting gravities of the 1850's. Gose had a high finishing gravity with attenuation of around 60%, indicating that the beer might have been served young and with some amount of residual sweetness [5].

See also:

Video

Milk the Funk Gose Recipe

 
MTF Gose
Description

The Milk The Funk Gose is an 8 gallon (8 gallons in the fermenter) recipe for a lemony, tart, and lightly salty beer that will quench any thirst on a summer's day. This recipe is an 8 gallon, no boil recipe, and is made for a system with 73% efficiency. Please adjust the recipe to fit your system.

Stats
  • 1.035 OG
  • 1.004 FG
  • 4.0 ABV
  • 2 SRM
  • No hops if possible. If hops have to be used, then ~3-4 IBU from mash hops
  • Mash 60min @ 145°f
Fermentables
Malt Weight  %
Floor-Malted Bohemian Wheat (DE) 5 lbs 50
Floor-Malted Bohemian Pilsner (DE) 5 lbs 50
Extract Version * Weight  %
Briess CBW® Bavarian Wheat Dried Malt Extract (or similar) 3 lbs 50
Briess CBW® Pilsen Wheat Dried Malt Extract (or similar) 3 lbs 50
* Note about the extract version: Devin Bell has also used 70% wheat DME to 30% pilsner DME and 100% wheat DME with good results. Briess CBW® Bavarian Wheat DME is 65% wheat and 35% barley.
Adjunct
Adjunct Weight Time
Salt (fleur de sel) 0.5 oz 0 min
Ground Coriander Seed 1 oz 0 min
Hops

No hops if possible. Any amount of hops will prevent lactic acid production with Lactobacillus plantarum. If hops have to be used for legal reasons (for commercial breweries, for example):

Hop Weight Use Alpha Acids
Golding (UK) 2 oz Mash hop, or add after souring 8 AAU
Yeast / Bacteria
Name Laboratory Product ID Starter Attenuation
Lactobacillus Blend (brevis, delbrueckii, and plantarum) * Omega Yeast Labs OYL-605 None N/A
Brett Sacc Trois White Labs WLP644 1 vial in 500 mL DME starter for 5-8 gallons 87.5
* If OYL-605 is not available, substitute it with a probiotic culture such as Goodbelly Mango or Swansons Plantarum. See Culturing From Probiotics [6].

Steps

  1. 1-2 days before brewing make a 1 liter starter of 1.040 wort, and add your vial of WLP644. Let it sit at room temperature until use. Also make 1 liter of 1.040 wort, and pour OYL-605 into the starter. Incubate 24-48 hours at room temperature to increase the cell count.
  2. Mash in at 145°f for 60 minutes; if hops have to be used, make sure to add the hops to the mash.
  3. Sparge as normal.
  4. Bring the wort to a boil, add salt and coriander, and then turn the heat off (no need to boil for more than a couple of minutes).
  5. Adjust PH ~4.2 to limit growth Clostridium butyricum and other potential off-flavor bacteria. Not necessary, but this is a best practice suggestion. See How to Pre-Acidify for instructions.
  6. Chill the wort down to 95°f, and transfer to a CO2 purged carboy or keg. Add the 1 liter of OYL-605 Lactobacillus Blend starter. Allow it to sour for 24 hours. No external heating is required.
  7. After the souring phase, chill the soured wort down to ~70°F and pitch WLP644 Trois (boiling to kill the Lactobacillus before adding the WLP644 Trois is optional; see kettle souring). You can aerate if you feel necessary. After 2 weeks a stable gravity should be reached.
  8. Rack or transfer off as normal to bottles or a keg.

See Also

References

Retrieved from "http://www.milkthefunk.com/w/index.php?title=Gose&oldid=7565"